Open Nav

齿轮GEARS

以下是资料介绍,如需要完整的请充值下载.
1.无需注册登录,支付后按照提示操作即可获取该资料.
2.资料以网页介绍的为准,下载后不会有水印.仅供学习参考之用.
   帮助中心
资料介绍:

齿轮GEARS(中文4200字,英文2700字)
齿轮是成对运转的直接接触体,它们通过连续啮合的称作齿的突出物把运动和力从一根转轴传递带另一根转轴上,或从一根转轴传递到齿条上。图7所示是四种主要的齿轮(正齿轮、斜齿轮、蜗轮和锥齿轮)以及齿条小齿轮.
齿廓  齿轮齿的接触面必须排列得使传动是流畅的,即所传递的负载决不能依赖摩擦接触。正如在分析直接接触体时所指出的,这要求接触面上的公法线一定既不能通过主动轮的枢轴,也不能通过从动轮的枢轴。

GEARS
   Gears are direct-contact bodies , operating in pairs, that transmit motion and force from one rotating shaft to another , or from a shaft to a slide (rack), by means of successively engaging projections called teeth . The four main types of gears ( spur , helical, worm ,and bevel) and a rack and pinon are shown in Figure 7.
Tooth profiles. The contacting surfaces of gear teeth must be aligned in such a way that the drive is positive ; the load transmitted must not depend on frictional contact . As shown in the treatment of direct-contact bodies , this requires that the common normal to the surfaces must not passs through the follower .

[来源:http://Doc163.com]


Most gears are also required to hae tooth proflies of such a shape that the velocity ratio of the gears remains constant (unless otherwise noted ,this article will deal with such gears only ).thid requires that the common nomarl must cut the line between the pivots at a fixed point. [来源:http://Doc163.com]

  • 关于资料
    提供的资料属本站所有,真实可靠,确保下载的内容与网页资料介绍一致.
  • 如何下载
    提供下载链接或发送至您的邮箱,资料可重复发送,若未收到请联系客服.
  • 疑难帮助
    下载后提供一定的帮助,收到资料后若有疑难问题,可联系客服提供帮助.
  • 关于服务
    确保下载的资料和介绍一致,如核实与资料介绍不符,可申请售后.
  • 资料仅供参考和学习交流之用,请勿做其他非法用途,转载必究,如有侵犯您的权利或有损您的利益,请联系本站,经查实我们会立即进行修正! 版权所有,严禁转载
    doc163.com Copyright © 2012-2024 苏ICP备2021029856号-4